|
Tractor Talk Discussion Board |
Re: Truck Help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on June 23, 2007 at 20:27:44 from (72.19.170.5):
In Reply to: Truck Help posted by Russell inTex on June 23, 2007 at 18:24:49:
Agree its most likely the fuel pump. Had a chevy van do the same thing some years ago. Befor the engine is running, the computer assumes the pressure at the fuel rail is where its supposed to be and controls how much fuel it injects by opening the injectors for a set period of time. If pressure is low, there isn't enough fuel delivered through the injectors to start the engine. Once the engin starts, the computer adjusts the length of time the injectors are open based on RPM and throttle position, and can compensate somewhat for a weak pump. There's a schrader valve on the fuel rail that you can connect a guage to. The manual should tell you what pressure there should be with the engine not running. The fact that it tries to start would indicate that there's some fuel, so its probably not an electrical problem. Some Chevy's also have a pressure damper on top of the pump that can also fail, but if I had to go to the trouble to drop the tank I'd replace everything in there. Keith
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|