|
Tractor Talk Discussion Board |
Re: Hay spear on a loader bucket
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jeff Oliver on June 22, 2007 at 13:45:45 from (74.38.173.172):
In Reply to: Re: Hay spear on a loader bucket posted by Kenneth Macfarlane on June 22, 2007 at 11:11:37:
Well i went ahead and welded a peice on the top of the bucket to put the spear in. I figure I can get about half of the bale in the bucket. I do plan on building something where I can take the bucket off but this should hold me for right now. The way the bucket is built the end of the top is about 23 inchs from the front of the bottom.
This thing has been converted from one cylinder in the center to 2 of them on either side. For what I am doing I would rather have the single cylinder but what the heck.
Replies:
Home
| Forums
Today's Featured Article -
The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
