|
Tractor Talk Discussion Board |
Re: question on hyd cylinder linkage
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Areo on May 19, 2007 at 07:49:33 from (209.103.231.148):
In Reply to: question on hyd cylinder linkage posted by Nebraska Kirk on May 18, 2007 at 21:30:43:
Another way would be to have the rear of the cylinder go to a mount that has a horizontal hinge pin. (The mount itself can hinge).That would allow the motion you need to raise and lower the mower. The pin through the end of the cylinder could then allow rotation when the mower breaks away. HTH Areo
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
