|
Tractor Talk Discussion Board |
Re: Shop lights
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by neblinc on May 17, 2007 at 09:58:15 from (24.123.122.114):
In Reply to: Shop lights posted by oldoliverlover on May 17, 2007 at 08:18:35:
There are lots of factors in determining your lighting needs. Ceiling height, number of lumens, budget. I went with the T8 bulbs in a 4 bulb surface mount fixture using 5000 kelvin bulbs. I think I have 24 fixtures in my 40 x 50 shop with a 12 foot ceiling and it is really bright. If you have a local lighting company, they have software that will give you all the specs and layout. I was lucky and found my fixtures used, got them for less than half of new, just had to pay more for bulbs, but they are rated for 10,000 hours. My walls and ceiling are white and a light gray floor so that helps also. Randy
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|