Howse 6' bush hog (washer holding bell to shaft)

Posted by David Lee Hawkins on May 13, 2007 at 14:13:43 from (66.19.112.57):

There is some kind of washer with multiple teeth that slips around the shaft of my Howse 6' bush hog. The bell housing with the blades attached go onto that shaft and the nut/washer tightens it all down.

The shaft has teeth cut into it on the end that fade smooth about an inch and a half up the shaft. I am missing the washer that fits on the shaft. The blades and the bell shaped disk slip around the shaft easily.

The person I purchased the tractor from had tack welded the bell shaped disk to the mower shaft. That is a bad idea and I would like to fix it correctly.

Where can I get one of these washers?
Is there an alternative solution?

Thanks,

David Hawkins

Replies:

• Re: Howse 6' bush hog (washer holding bell to shaf PGN 04:34:48 05/14/07 (0)
• Re: Howse 6' bush hog (washer holding bell to shaf oliver power 04:11:49 05/14/07 (0)
• Re: Howse 6' bush hog (washer holding bell to shaf Rod in Smiths Falls, ON, 17:15:13 05/13/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]