|
Tractor Talk Discussion Board |
Re: Lets tell some stories about loading / unload
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ironsales on May 11, 2007 at 09:58:53 from (63.168.147.151):
In Reply to: Lets tell some stories about loading / unloading posted by Chances R on May 11, 2007 at 07:12:45:
i was loading a half dead m farmall on a trailer for my cousin and we were using a borrowed deck over implement trailer we all heck broke loose, the fronts and rear were not very good so i was easing up when halfway up the ramp the right side rear tire decided it was a good time to come off the rim, had the winch hooked up, and it helped keep the tractor from rolling over, but that was a heck of a ride, i saw my life flash before my eyes, and upon further inspection, i realized my cousin, who is a "PROFESSIONAL" truck driver didn't have the ramps spread far enough apart, its my fault too, i didn't look at the ramps, i do now, and i don't trust anyone with them
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|