|
Tractor Talk Discussion Board |
Re: PLEASE front pump info
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JMS/MN on May 08, 2007 at 06:55:52 from (204.73.106.15):
In Reply to: PLEASE front pump info posted by charger on May 08, 2007 at 02:43:02:
This is how I added a front shaft to an AC WD cast pulley: Welded a short length of one inch shaft to the center of the pulley. Machined that down to 3/4 inch, milled keyway. Used a lovejoy coupler to the pump the first time, double sprocket and roller chain the second time. Start with the larger shaft so if not perfectly centered after welding (it won't be!), you have enough stock to end up perfectly true . This works on a WD because the pulley is not held on with a center bolt- it has a setscrew on the side. If yours has a center bolt, weld the shaft to a disc that can be bolted on the face of the pulley. Machine work must be accurate- any wiggle will tear out the pump or coupling.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
