|
Tractor Talk Discussion Board |
Re: Removing fanshaft from 1937 JD A
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DRL on May 05, 2007 at 21:47:46 from (24.32.126.45):
In Reply to: Removing fanshaft from 1937 JD A posted by 1 Dollar on May 05, 2007 at 21:21:32:
Either the radiator or governor has to be moved. Depends on how far you are torn down already as to which is easier. Radiator is held down by two bolts. If they haven"t been removed since "37, they may be quite difficult and the possibility of breaking them off is quite high. The governor can be slid back enough to get the clearance you need, but you will need to open the crankcase and disconnect the oil line to the governor. I usually turn the engine over until it is on compression on #1 cylinder before I take the governor loose. This makes it easier to set the mag drive at the proper spot when you go back together with it.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|