Re: OT - Hammermill horsepower

Posted by gene bender on May 05, 2007 at 15:59:09 from (67.55.226.214):

In Reply to: Re: OT - Hammermill horsepower posted by Mike Van on May 04, 2007 at 03:58:20:

The rotor part of the hammermill will weigh a lot more than your wt unless its a little 4in but he says the screens are a lot wider than 4in and you are using 10hp capicitator start maybe even 3 phase correct so he has to have some good power to get it started now if he can build a tightener to clutch the belt some it would help. Also going to need the correct motor. Ground thousands of bushels with the B ON A 9IN mill and you had to slip the clutch to start rotation but then did just fine too bad we didnt have the bigger pulley on the B as we could have had more capicity per hr.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]