Tractor Talk Discussion Board |
Re: pulling power
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by LamborghiniR904DT on May 04, 2007 at 05:20:54 from (72.51.174.19):
In Reply to: Re: pulling power posted by Aaron Ford on May 02, 2007 at 22:26:06:
So I hooked up to the block and tackle last night; the double pulley to the stump and the single pulley to a tree. First, I broke the log chain at the tree. Then I broke a 3/4" wire rope at the tree. Physics says that if my tractor was pulling 9,000# on the 3/8" wire rope, then I had 36,000# at the stump and 27,000# at the tree. By the way, the stump did not budge. Back to digging at its roots.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|