Tractor Talk Discussion Board |
Re: JD 5020
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by 37 chief on April 27, 2007 at 22:06:59 from (70.181.167.25):
In Reply to: JD 5020 posted by 71ford100 on April 27, 2007 at 18:02:10:
That is a fairly old tractor. It would be good to have a standby. I bought one a few years back. first thing it needed was a trans input shaft seal. That was quite a job. Next year the rear axle pulled out fron the final drive. Another big job. I still have mine. It is a fairly powerful tractor. If you but the tractor it may turn out ok. It would probably do what you wanted if it didn't brake down. Stan
Replies:
Home
| Forums
Today's Featured Article -
Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|