|
Tractor Talk Discussion Board |
Best thing since sliced bread...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on April 27, 2007 at 18:39:55 from (70.224.214.115):
Or atleats that's what it seems like to me. I got sick of putting the duals on the tractor's with a big 1 1/8" wrench, so I took advantage of the water jet at school. I found a chunk of 1" plate and burnt out the 1 1/8 hex with 1 3/4 OD and a 1/2 square to fit over the impact with the same OD. I found a peice of sch. 80 pipe and hasd the lathe guy at work bore out the hex about 1/8" or so deep for the pipe and turn a step on the square side to go inside the pipe. I welded it all up, it runs true and works FRIGGIN GREAT!!! Just get the dual up there and be quick with the 1st clamp, easy going from then on. What used to take 45 min- 1 hr per side with a wrench, now takes maybe 30-45 min. for both!!! I'm hooked... Actually kinda exited to put on the smaller 18.4-34's on the 285- those should be a cake walk! Those bigger 18.4-38's sure were a heck of a lot easier. No problem getting them off again either. Wasn't bad before but now just zip the nuts loose and drive away, don't worry about fussing with the wrench...
Donovan from Wisconsin
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
