Tractor Talk Discussion Board |
Re: David in Wales - thanks for the response.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike (WA) on April 27, 2007 at 08:28:49 from (69.10.197.227):
In Reply to: Re: David in Wales - thanks for the response. posted by Mike M on April 27, 2007 at 05:43:18:
REALITY PLOUGHING! A totally different kind of contest. Find some scruffy old place- assign everyone a small section. Doesn't matter if my section isn't exactly the same as your section, because each section would have a "degree of difficulty" multiplier. You get to make two runs, up and back, that won't be scored, so you can make adjustments to compensate for conditions. No limit on adjustments- change coulters, change shares, landslides, you name it, bring in a different plough if you want to. You got two hours to get ready- then the actual competition. That might be more of a test than ploughing a perfect soccer field.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|