Tractor Talk Discussion Board |
Re: O/T X Breeding
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rrlund on April 26, 2007 at 08:45:51 from (216.46.211.216):
In Reply to: O/T X Breeding posted by Ken-in-K on April 26, 2007 at 07:10:58:
I've read everything below. If you're going to be in the beef business,I wouldn't mess with the holsteins. I have one here that I've kept around just because she is blind. She breeds back and the big advantage to her is that she will feed any calf that gets near her,so if a heifer abandons a calf or something,she'll raise it. But as for what somebody said below about them gaining fast in the feedlot,that's bunk. They will gain faster than a straight holstein,but can't hold a candle to a straight beef breed. I do prefer cross bred cows,but crossed beef breeds,not crossed with dairy breeds. The straight beef are even more vigorous and healthy,take extremes in the weather better. We've found that crossing an Angus to a Limo or Simmental makes a good cow. We have 9 Herefords left here yet. We don't have great luck with longevity in the straight Herefords,their teats get to big too soon and the calves can't get their mouths around them. We do like the Angus Hereford crosses though,Black Baldies. We get fast growth on their calves,and I mean real fast. The cows tend to be a little smaller than straight Hereford and eat less,have smaller teats and more longevity. But,if you have some holstein cows or heifers,do what I did,they are worth good money,sell them and buy some good beef cows. Two holsteins will get you three or four beef cows and a HECK of a lot better calf.
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|