|
Tractor Talk Discussion Board |
Re: 12 3 bottom 3 point plow set up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mike3320 on April 25, 2007 at 15:05:23 from (71.60.169.8):
In Reply to: 12 3 bottom 3 point plow set up posted by Mark Collier on April 24, 2007 at 19:56:02:
i pull two bottom 14 jd plow behind a 33hp 4wheel drive tractor. no draft just position control put it on blocks set it a 7 inches. plowed ground wasnt plowed in thrity years about three acres. pulled at 3 1/2 mph just fine. no loader three 70lb weights. tires loaded. pulls better without loader. to much frontend weight.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|