|
Tractor Talk Discussion Board |
Re: Hydraulic Hose or Tubing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul Janke on April 23, 2007 at 18:56:19 from (216.166.168.53):
In Reply to: Re: Hydraulic Hose or Tubing posted by Tweeter on April 23, 2007 at 17:39:42:
Assume for now you run them in series and the loader is first in line from the pump. For normal conditions where you use the loader OR use the backhoe all is fine. But in the real world, you will probably get stuck someday. Now when you push down with the loader AND lift and pull the back of the tractor with the backhoe at the same time, the pump has the pressure of the two added together. That is hard on or may destroy the hydraulic pump. One end of the loader cylinder has this same high pressure on it. The other end of the loader at the same time has the same pressure on it as is being used by the backhoe. Not good for things.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
