Tractor Talk Discussion Board |
Re: PHOTO - almost finished
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by richard in nz on April 23, 2007 at 04:26:25 from (125.239.189.28):
In Reply to: Re: PHOTO - almost finished posted by Mike (WA) on April 22, 2007 at 09:03:39:
He should be coming down there with his other wheel in the furrow, the plough slid over on the crosshaft(or the drawbar on a trailed plough) to leave the wheel mark on the right side of the photo (his left) He would then slide the plough back to the normal place on the crosshaft throwing the final furrow and the sole furrow to the left of the photo, towards his own crown, leaving the final wheel mark on the right side of the photo. That part of scoring at a ploughing match is purely acedemic but those are the rules, he would have lost 20 points, a real shame, because apart from a bit of grass showing up the furrow seams, he has done a good job.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|