Tractor Talk Discussion Board |
PHOTO - oat seed furrow plough
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David in Wales on April 19, 2007 at 08:59:38 from (86.134.132.48):

Hi Gang; The next set of photos shows two champion ploughmen working on the same day in a match. The history of "oat seed furrow" ploughing goes back to the mid-1800's and continued until WW2. Now the art has been revived and its the most skillfull and difficult style. The grassland was ploughed 8" wide and 4" deep, the aim to bury all grass, and leave the furrows turned into a pointed top. When the seed was sown by a man scattering the seed by hand, most would fall into the bottom of the ridge, and when the soil was harrowed afterwards it would break down into a fine tilth leaving the seed in rows. Also by leaving the maximum area of soil exposed to the rain & frost would help the soil crumble. The ploughs were special designed and evolved over the years. The share points are wide to cut the whole width of the furrow, and the mouldboards (bodies) are some 4 feet long to turn over the furrow gently. This photo shows a 2 furrow trailed plough which has been heavily modified for match (competition) work. A plough like this would sell for over $4000 today - they are rare and highly sought after. In the next pictures I will show more of the ploughs and the work they produce. I will explain what all the extra bits are for, and you will see how they form the furrow. Hope you enjoy. Cheers David
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|