Tractor Talk Discussion Board |
Re: O/T, Any body have a cheap easy way to cut roc
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David in SC on April 13, 2007 at 18:57:42 from (67.33.252.164):
In Reply to: O/T, Any body have a cheap easy way to cut rocks posted by old on April 13, 2007 at 14:08:04:
Hey Old, I used the Dex-Pan with great success. The problem is you have to drill large holes to pour it into. That is not cheap if you don't have the tools. A great alternative that I used was a sledgehammer and railroad spikes. If you can locate a vein in sedimentary rock and get some spikes started, sometime you can break them with a little effort. Be sure to wear goggles and have them well into the rock before you lay into them with a good pound. Good luck, David in SC
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|