Re: M Farmall Fan Belt

Posted by Jon Hagen on April 13, 2007 at 15:47:21 from (75.104.56.247):

In Reply to: Re: M Farmall Fan Belt posted by Big un on April 13, 2007 at 15:10:16:

The set screw with lock nut that locks that threaded pulley half in position, fit quite deep into one of 4 grooves on the pulley to lock it. You need to back that lock screw out a long way so the nipple end of the lock screw clears that deep grove it seats into. Best may be to remove the lock screw untill you get the belt tight,as then it can not jam up as it would if not loosned far enough,plus you can look down the screw hole to make sure it is centered over a lock groove before you install the lock screw. Bottom the screw snug in a lock groove, then tighten the locknut.

Replies:

• Re: M Farmall Fan Belt rrlund 16:16:15 04/13/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]