Re: Help A Dummy?

Posted by PatMz on April 12, 2007 at 15:46:02 from (4.228.117.140):

In Reply to: Help A Dummy? posted by Allan In NE on April 12, 2007 at 13:50:45:

In the time it'll take you to drill those holes (I'm assuming these are the plates for the F11 like you showed me a couple months ago) you could almost drive to Sydney, North Platte, Cheyenne or Denver and have them fabricated! Mine were only $26 at DenCol Iron, about the same as good bits, ready the same day I faxed the dimensions. You might could get by with cheaper bits, real slow and with lots of oil..........

1/16 over is standard, I went with 5/8 and hand reaming to minimize slip.

You got a drill press? Drilling freehand will test your mettle (pun intended).

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]