|
Tractor Talk Discussion Board |
Re: Johndeere engines.....thumbs down..way down.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by The Dukester on April 11, 2007 at 13:48:41 from (4.229.192.146):
In Reply to: Re: Johndeere engines.....thumbs down..way down. posted by Bob on April 10, 2007 at 17:13:26:
You could probably find someone to turn the old Sleepy John Deere up so it would have snarling power and pollute the daylights out of the air around it. Did you ever notice all the black smoke that comes out of most high powered diesels when they are pulled hard...what do you think that is?? Someday someone with a "Dudley Doo Right Desire" is gonna start taking pictures of dirty high powered diesels and raising h--l about it and that will eventually bring an end to tractor pulling, antique tractor shows and high powered dirty diesel engines. Run the living h--l out of your Massey.....while you can.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|