Re: O/T J B Weld

Posted by lucasss on April 08, 2007 at 11:23:05 from (209.240.206.208):

In Reply to: O/T J B Weld posted by Turke Bros. Farms on April 08, 2007 at 08:10:16:

i think getting the surface clean and ruffed up a bit and letting it cure for 24 hours is the key to getting best results.i have even drilled small 1/16 holes along both sides of a crack and pushed the jb or deavcon into the holes and along the crack.the holes kinda rivit it to the surface. i now use deavcon plastic steel putty and like it better. can get a pound for 25.00 at gemplers.com .. but jb is pretty good too lucas

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]