|
Tractor Talk Discussion Board |
Re: OT: Tried out the F250 today.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by T_Bone on April 03, 2007 at 12:11:28 from (4.240.90.71):
In Reply to: Re: OT: Tried out the F250 today. posted by Kelly C on April 02, 2007 at 21:16:01:
Hi Kelly, I bought a 27+5 Legend and that's 40ft over all. It's ok for length other than being in town. I'm planning on building a 6ft sleeper/camper area on the first 6ft so it's be just right for two/three tractors. Had I not wanted the sleeper on the front then a 20+5 would have been all I wanted. With the 3rd ramp folded up that gives a full 25ft x 8.5ft of flat deck space if needed. Forget about building your own trailer as I bought the 27+5 new for $200 less than my estimated material cost, $6400. The 20+5 were in the $5200 range. I don't know how them boys can build them so cheap and give the quality of trailer they produce. Isn't that turbo power neat at 2200rpm to 2400rpm? Just like installing a second engine. For 90% of my pulling I pull at 1800rpm which gives me great fuel mileage and will still maintain 60mph on the flatlands while pulling 24kGCW. T_Bone
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|