|
Tractor Talk Discussion Board |
Re: My New Iron Hauler
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike (WA) on March 30, 2007 at 08:30:26 from (69.10.197.227):
In Reply to: Re: My New Iron Hauler posted by Don L C on March 29, 2007 at 19:09:41:
Not to answer for in-to-deep (but I will), most of the fender type trailers are at most 82" between fenders, so probably no. I have hauled wider tractors on mine, by driving them on from the front. Take off the trailer jack, block up the front corners of the trailer so the tongue just clears the ground when you lower the trailer, then put up ramps on the front and drive the tractor on so its facing rearward. If you run the rear tires of the tractor right up to the front of the trailer fenders, it will be balanced pretty well. Hauled an IH 674 and an AC D17 that way, without incident.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
