Tractor Talk Discussion Board |
Re: cleaning concrete blocks
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rgvtx on March 29, 2007 at 20:09:40 from (64.12.116.14):
In Reply to: cleaning concrete blocks posted by BSer on March 29, 2007 at 16:30:07:
My first thought was to go ahead and use them as they are and once they are up and the mortar has had time to dry, then spray them with some bleach and water mixture. But, if you can't get to both sides that won't work. The pressure washer will clean them up, but as you know you won't kill the mildew. Bleach is the only way I know to kill it safely. Muratic Acid is great for cleaning concrete and brick, but is far from safe. Any chemical that gives off green smoke is a bit scary to me although I have used it for removing mortar from brick, cleaning some stains on a driveway and even to clean out a gas tank one time. The bleach mixture I recall using was one cup to a gallon of water. Since your doing a lot, I would use a pressure washer with a siphon tube to draw the bleach. You will use the soap tip on the wand for the bleach, then switch to a smaller tip but not too small. Try a 40 first and if the stuff is stubborn you can go all the way down to a 15 degree but just don't get too close. Brick is usually very porous but since you have some aged brick it may not be as bad as the brick we buy these days. Just imagine if you had stored lumber all these years? What little you would have left by now that the termites hadn't eaten would have mildew on it too! Ain't living in the south great? RGVTX, Tip Of Texas
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|