|
Tractor Talk Discussion Board |
Re: Compression ratio and octane rating
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on March 26, 2007 at 19:14:03 from (72.19.170.5):
In Reply to: Compression ratio and octane rating posted by hogman_2002 on March 26, 2007 at 10:32:44:
Also depends on whether its a carbureted or electronic fuel injected engine. Current electronic fuel injected engines have knock sensors, and will automatically retard the timing to whatever is necessary to avoid knock. As others have noted, for a carbureted engine there are a lot of variables. Does it have to meet emissions standards? EGR affects knock, as well as engine temperature and load, and the timing curve (there's probably other factors as well, but that's what comes to mind) I can remember setting timing on older cars by advancing the timing until it would knock under load, then backing off just enough to avoid knocking. Keith
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|