Tractor Talk Discussion Board |
paulson loader cyl.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ERIC BAADER on March 25, 2007 at 14:46:27 from (69.179.52.141):
I have a MM JET STAR 3 with a paulson all hyd. loader. My lift cylinder on the right (passenger) side seems to go out and back about half as fast as the left one. I made sure my hyd. lines were the same length from the tee's to the cyl. the two lines to the front ports are 4 feet the lines to the back ports are 3 foot . I don't belive that all 4 lines need to be the same length. I did notice that the hose to the left cyl. back port (port closest) to the set.Is the same length as the other side but it is only 3/8 inch. Not 1/2 inch like the rest of them.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|