Tractor Talk Discussion Board |
Re: LP versus Gas engine heads
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Robert Searcy on March 23, 2007 at 08:08:56 from (70.12.201.62):
In Reply to: LP versus Gas engine heads posted by INCase on March 23, 2007 at 07:53:02:
Well, I dont know a lot about them but here is what i experienced with our 400 LPG Farmall. It had a little different head design than the gasser. I dont know about the difference in seats but i do know the valves themselves had an S or SF stamped in them as they were Sodium Filled due to the extra heat created. I am not sure if there was any difference in compression ration or not. I know our LPG was a hard starter when it was cold. Always had to ether it. It ran great and as long as we werent pulling a plow or working it hard we ran it on vapor, turning the liquid valve off on the tank. It worked really well in a hot sun on that tank durning the day. I never really noticed a difference in power although some said you could tell when under a hard load. I never tried to compare, when plowing, I always just opened up the liquid valve and went to work. Turned it off when I left the field etc......... IT was a great tractor and surprisingly economical I believe. The T/A was a weak spot and the power steering always leaked, it was a charlin. IT was a row crop and with the loader on it, it was hard to steer even with the charlin. I have heard the 450 LPG heads are different as well, not sure how but they are and are desired by the pulling community. That tractor did have flames that came out of the exhaust when working hard. They were pretty blue and the muffler got cherry red. Very distinctive odor as well but man did the oil stay clean looking in it. Just like you poured it out of a can. Never got dirty looking.
Replies:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|