|
Tractor Talk Discussion Board |
Re: DIGNITY AND INTEGRITY OF FORUM
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Thack on March 21, 2007 at 09:58:17 from (4.161.93.166):
In Reply to: DIGNITY AND INTEGRITY OF FORUM posted by Tom43 on March 20, 2007 at 19:35:56:
Just a little constructive critism here. I have read both posts and to be honest I am more offended by this post than the Rosie post. Rosie is a public figure who has decided to stand for things that may feel are very immoral. But in your defence of "Dignity and Integrity" you lable others Klan members? My grandfather was a southern preacher who believed all men were created by God. He hated the Klan and their teachers of evolution. Evolution???? Yep, it provided the racist a way to accept that blacks were human but less developed. He told me one day homosexuality would become acceptable. That would lead to gay marriage which would be followed by people living on the Down Low. Oprah did a show about living on the DL recently. The DL would be followed by open marriage, then no marriage, followed by beastuality, pedifilia and lastly there would be no more rape because no one can deny another enjoyment. Several States are debating beastuality right now. So Tom, where do you draw the line? If it is at beastuality, welcome to the club as you are now a racist Klan member.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|