Tractor Talk Discussion Board |
Re: On-Rim Tubeless Repair Question ....
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by iowa_tire_guy on June 03, 2007 at 19:30:12 from (69.63.29.215):
In Reply to: On-Rim Tubeless Repair Question .... posted by MMB on June 03, 2007 at 11:35:15:
As a tire shop there is far too much liability to plug a DOT tire. Also I wonder why anyone would pay me to do what they can do themselves. If I find a plug in a tire that isn't leaking I will cut it off and put a patch over it on the inside while I'm in there. To say a plug never leaks is a lie also because I fix leaking plugs all the time. And a plug will damage a belt if it does not follow the path of the injury so there is still a unsealed hole in the inner liner of tire. This allows the air to get trapped in between the belts so they separate. Also you never know what the damage to the tire is unless you are inside so when you plug a tire you are assuming there isn't a larger injury than what it appears. It is acceptable to plug a tire from the inside out because you know you are sealing the injury and it isn't too large. And according the Tire Manufactures Association you are to plug and patch tires from the inside to seal the air leak and to seal water from getting to the steel belts.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|