Tractor Talk Discussion Board |
Re: Just About
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RAB on March 10, 2007 at 23:50:02 from (195.93.21.42):
In Reply to: Just About posted by Allan In NE on March 10, 2007 at 15:59:19:
C"mon Allan. That thing don"t even look as though it is half way up. At full lift the weight will be much closer to the axle and also it will be out of sight, (and out of mind, as they say). Run down the road in top gear and do a quick turn or two - well one would be enough - and that bale would be much closer to the ground!!! - and so would you!!! Dont cut anything out of the frame, keep it as it is. Remember it is a LOADER, not a transporter! Sometime you will want the lift. Make a transport lift for the 3-point, just so much safer and easier on those front wheels, axle and the steering gear. You got plenty of time (or so they say) to figure out and fabricate another tonne of steel. Regards, RAB
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|