Tractor Talk Discussion Board |
Re: Allan in NE - Hydraulic splitters
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IaGary on February 28, 2007 at 04:26:24 from (207.177.17.177):
In Reply to: Re: Allan in NE - Hydraulic splitters posted by Allan In NE on February 28, 2007 at 04:16:55:
With the switch untouched its a straight thru deal on the oil flow. When you press the switch it pulls both pluggers across and redirects the oil to the other hoses to run the other cylinder. You want to plumb it so that it is a direct flow to the cylinder you want to use the most. Both solenoids are activated when the switch or power is applied. Change your wires around on the solenoids to acheive this. Gary
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|