Tractor Talk Discussion Board |
Re: could a WD handle it?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kevin (FL) on February 23, 2007 at 11:40:13 from (70.149.236.146):
In Reply to: could a WD handle it? posted by Tim Shultz on February 23, 2007 at 06:46:43:
Tim, My neighbor has a WD and the PTO has broken at least twice while bush hogging. I don't remember if the gear broke or the shaft itself, but I checked around and the WD is not known for a robust PTO setup. It's mounted on the outside of the tractor at the bottom of the transmission case. I think as long as you're just cutting grass, the machine will be OK but if you plan on cutting small trees and heavy bushes (like I do with my old Ford diesel), I'd be pretty careful. Probably should also install a slip clutch on the mower gearbox shaft too.
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|