Tractor Talk Discussion Board |
Re: Chevy 4WD Actuator Front Axle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on February 17, 2007 at 09:43:53 from (69.178.229.154):
In Reply to: Re: Chevy 4WD Actuator Front Axle posted by Tweeter on February 17, 2007 at 09:24:36:
The one at Summit is the style you want.
You will need to get a conversion wiring harness from Chevy to make it work, though. The new style fast and positive unit WILL NOT work unless conversion harness has already been installed, or you install it. The harness runs back to the upper LH side of the transfer case, and gets spliced into a brown wire at a 2-wire lug that is connected to a screw-in switch on the transfer case. Conversion harness part #'s 1237 6316 (old part #) 8895 9465 (new part #) Expect to pay about as much for the conversion harness as for the actuator. Clear as mud?
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|