|
Tractor Talk Discussion Board |
Re: 5.9 Cummins Oil Pressure
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NC Wayne on February 15, 2007 at 16:33:32 from (205.188.117.14):
In Reply to: 5.9 Cummins Oil Pressure posted by Mike Tessman on February 15, 2007 at 15:30:51:
I had a brand new 4 cylinder B series, bought straight from Cummins, that never ran over 50psi cold. When hot, at an idle (1250 RPM in this application, an air compressor unit), it maintained around 10. It ran for several years like before my customer traded in the machine the unit sat on for a newer model. I routinely deal with the guys that now have it and they've never said anything about any problems with it in the time they've had it. If yours is showing zero though I'd first check the guage and make sure it's not lying, then if it's not you might try running a little heavier weight oil and see if that makes a difference, and go from there based on those two things.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|