Tractor Talk Discussion Board |
Re: Hey Old!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hal/WA on February 11, 2007 at 18:16:28 from (66.45.175.118):
In Reply to: Re: Hey Old!!! posted by old on February 11, 2007 at 16:39:00:
When we had our 1973 14x60 Fleetwood, I had a lot of roof leak problems, especially when it snowed a lot and it was quite cold. One time a bunch of water started coming in through the roof-mounted swamp cooler. It was dammed up behind ice dams and was more than 6" deep at the cooler! I chopped openings in the ice dams and then put an electric heat cable across the mobile home roof at the low point. I also had some problems with small leaks at the joints between the metal roofing sheets. I found that covering those joints with the fabric tape and then coating the whole roof with Snow Roof cured most of those leaks. But I had to recoat the roof at least every other year or it would leak somewhere. Our old mobile home sure didn't owe us anything--it was mighty cheap living for a lot of years. When we finally built a new house about 10 years ago, I had a terrible time getting rid of it. For a while, I wondered if I would have to pay someone to haul it away. But then I more or less gave it to a young couple with 3 little kids who needed it badly. It was in reasonably good shape, and the last I heard, they were still living in it. But if I ever get another mobile home, I want one with a more steeply sloped roof that I would not have to fool with so much. And 6" thick walls, so it would hold the heat better. But then I doubt that I could get such a home for the $8000 I paid for the 73 either. Have a good one!
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|