Tractor Talk Discussion Board |
Re: Update on DUH auction
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by evilboweviel on February 08, 2007 at 05:43:41 from (75.180.10.17):
In Reply to: Re: Update on DUH auction posted by VADAVE on February 08, 2007 at 04:08:55:
after you slide those rear wheels out to plow or ? a few times you will wish you had spinouts. As they don't slide at all easy with that dual hub. Beeen there and done it. two of us with a spud bar and that was using a strip with ballbearings in it that worked fine on the 1650 with reg hubs. Then after fighting that for a hour or two to just move one side in or out. We would get the Ford 4000 and change both sides with the spinouts real fast Ron
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|