Tractor Talk Discussion Board |
Re: flipping cold out there
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Turke Bros. Farms on February 05, 2007 at 08:09:07 from (205.188.117.14):
In Reply to: flipping cold out there posted by Dave from MN on February 05, 2007 at 05:20:57:
Good grief! When isnt it supposed to get warmer? My toes are freezing and I just walked to the Greenhouses and back. Man it was warm in there 75 degrees. Now we are all smart men, Whay cant a guy run some water pipe though a greenhouse warm it to 80 and then run it through registers in his house. Its zero out now, and it was 75 in there and no furnaces running we use them at night only. There would be alot of water pupming but i bet it would be cheaper than outer means. DTURKE
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|