Tractor Talk Discussion Board |
Re: Can it be done safely
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DJ930 on February 04, 2007 at 10:45:58 from (216.51.171.43):
In Reply to: Can it be done safely posted by old on February 04, 2007 at 10:32:10:
Old I wouldn't want to do that, Be way to much weight on the draw bar IF front end would stay on ground. I pulled a 10X50 home about 22 miles with a 3/4 ton pickup one time. Thought I'd be smart and put concteat blocks in rear of trailer, hooked on, put wide load signs on, started down hiway, get over 40 mph pickup started to sway. Make long store short had car in front and back drove slow, got home OK, on main HIWAY. My thoughts. DJ
Replies:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|