Re: harveststore

Posted by Eric in IL on January 30, 2007 at 08:13:53 from (67.72.98.45):

In Reply to: harveststore posted by mjw on January 29, 2007 at 20:56:36:

It cost me about $6400 to convert one in 2002. I had the roof vent made at a local sheet metal shop and used a motor that I already had on the unloading auger to save some dollars. Prices have most likely gone up since 2002. My only complaint is the floor has some sags where it meets the wall of the harvestore. The floor on mine was not attached to the wall. It is only held up by the four inch tall floor supports. I used the Cady System. Here is a link to them:

• Cady Aeration

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]