Tractor Talk Discussion Board |
Re: What's your secret?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on January 26, 2007 at 07:14:47 from (148.78.243.26):
In Reply to: What's your secret? posted by PatMz on January 26, 2007 at 05:51:18:
Pat, Horses are born with the instinct to run from everything. It is their only defense in this world and you have to get across that "instinct" by gaining their trust. They also have a high level of curiosity and they always want to please after they finally realize that you won't hurt 'em. On a newborn, I start working with ‘em on the third day, so you are just a natural part of their world and they accept you from the get-go. Work with the horse enough and he’ll want you to halter him up. He’ll expect it as part of his routine. Use lots and lots of patience, continually talking to and stroking the pony WITHOUT any fast, sudden movements. I start at the head and work back; can usually have them leading and lifting their feet the first day. Remember, you have to work both sides of the horse because their brain is split. What he learns on his right side will be totally new to him on his left side and he’ll have to go thru the whole learning process again on that side. Never “chase” a horse ‘cause you’re just playing his game. Use a small round pen. I work 'em twice a day for about an hour or an hour and a half at a time. Two things: Are you gonna cut that stud? I’d be for getting it done BEFORE his training and the sooner the better. Also, don’t leave that halter on him continually. Put it on and take it off repeatedly. Plus, you don’t want to come out some morning and find him hanging dead on a fence post; that is a real stomach turner to see. :>( Allan
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|