|
Tractor Talk Discussion Board |
Re: Latex gloves while wrenching ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DAN9-Midwest on January 20, 2007 at 10:22:36 from (67.142.130.32):
In Reply to: Latex gloves while wrenching ??? posted by Greasy fingers on January 20, 2007 at 05:57:44:
Yes, I have worn rubber/latex gloves for 10 years. Did it by accident at first while doing hydraulic work and wear them whenever really greasy or dirty. They work wonderful. Also, I wear in cool or cold weather and they are like a thin glove. I buy gloves by the two-pack at Sam's club for $9.50 and get 200 individual gloves. Bonus to staying clean is the chemical or solvent thing and I always wear with spray chemicals or while spray painting. Yes, people will tease you at first and I never really got over that.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
