|
Tractor Talk Discussion Board |
Re: OT. Scrap metal prices?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kent in KC on January 16, 2007 at 12:18:28 from (24.123.98.130):
In Reply to: OT. Scrap metal prices? posted by Robert in Md on January 15, 2007 at 19:18:07:
Not sure the price but a few weeks ago someone ripped down several hundred feet of 100-pair phone cable from in front of our bldg and apparently sold it. Put our phones down for a few days. Around here, if you go asking junk metal dealers about whether they've seen such and such their only response is 'Are you a cop?'. They're as much to blame as the thieves. You have to watch your battery cables, radiators and don't have a gold filling in your teeth. They'll come in after that too!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|