|
Tractor Talk Discussion Board |
Re: 1995 Dodge Ram 4x4 front axle engagement for f
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by marlowe on January 15, 2007 at 20:25:43 from (12.213.112.57):
In Reply to: Re: 1995 Dodge Ram 4x4 front axle engagement for f posted by marlowe on January 15, 2007 at 20:16:43:
on my 1990 i put lockout hubs on it and just locked the slide coupler over to the right with the fork on the back side of the slid coupler but on the 96 you can't put lockout hubs on it so i fixed it with a new coupler and shaft was not that costly to do both my trucks have over 200,000 miles and plow snow all the time. and what you said about off roading sounds like your truck was used a lot in 4x4. under full vac. it will push the motor back and then snap in again and you will get a clunk
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Dad's Old Silver King and Joe Capalco - by Woody E. Diehl. My father, Charles Diehl, grew up in the Elsworth, Ohio area during the Depression on a small working farm. I never saw the place, nor was I around during his early years. What I know about those hard times comes from listening to Dad and his old pals reminisce from time to time. One of the old timers that would sit with Dad and chew the fat about the 'good ole days' was Joe Capalco. Joe wasn't like most of my Dad's friends. He rarely worked that we knew of. Always had plenty of time
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
