|
Tractor Talk Discussion Board |
Re: O/T: '92 Caravan engine code
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by wildonewest on January 14, 2007 at 06:29:03 from (69.21.9.114):
In Reply to: O/T: '92 Caravan engine code posted by MeAnthony on January 13, 2007 at 21:42:34:
I'm not sure what code # 27 is but it sounds like to much fuel like perry said "bad temp sensor" or Allen "pluged converter" Also the o2 sensor(s)could be bad. o2 sensors read the air/fuel mixture and send that info to the PCM telling it to run rich or lean and o2 sensors only start working after they warm up. You may have 1 or 2. One before the converter and/or one after the convertor. Make sure you have no exhaust leaks before your last o2 sensor! Ck your wiring to the o2 sensors and make sure they are not riped off or burned off and if so splicing some times will not work because it changes continuity. If all wiring is ok to the sensor(s) try unpluging them each one one at a time while it is running poorly and see if it changes anything. also you could try to remove the one o2 sensor before the converter and tell how much exhaust blows out the port hole. If the converter is pluged it will blow air out the port like an air compresser more so then the tail pipe. I think it could be the temp or the o2 sensors but it could still be a bad injector dumping to much fuel. look at your spark plugs and see which one is fouled. if all is fouled it is a sensor/wiring problem and if you only find one fouled plug replace that injecter. It could be other sensors. Ck all wiring to the sensors. The battery could leak onto your wire harnes which is under the battery (bad idea by mopar) Hope this helps!! Good luck and let me know if you have any more? My email is open. Chris Hotchkiss, CO
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|