|
Tractor Talk Discussion Board |
Re: O/T spinal decompression therapy
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NE IA Dave on January 12, 2007 at 17:59:03 from (12.206.8.41):
In Reply to: O/T spinal decompression therapy posted by evielboweviel on January 12, 2007 at 09:35:38:
I do not know what the table thing you asked about is, so can not comment. I do however have a small table that you strap your anckles into and it lets you tip yourself upside down, or as upside down as you prefer. Kind of like a teder toder, It works great, just like physical exercise, I should do alot more. The comments on surgery are no doubt very valid, but I have a brother that was told surgery would never help. The same week he priced wheel chairs a friend made the coment of what do you have to loose? He had the life changing surgery He still walks hunch back at times--he says when he does he should be kicked as it is totaly a twenty year habit as he simply has no pain anymore. He now jumps out of spraying rigs, plays tennis, basicaly can do anything and no pain whatsoever. He did have a very expensive chair, like a fishing stool, then a soft bar (exactly like a crutch) came up under his arm pit to hold his weight. Another lever dropped the seat out and hung him by the arm pits. He has no regrets buying it as it did help a little. My dad used to roll up a blacket as tight as possible, lay it on the floor, then lay face down over the blacket (under his belt buckle). I have used it often, does make a diferance. I do not understand the L system as perhaps I should, but all of these pains in our family are lower back. I feel for you, it is imposible for some one to explain back pain to another person that has never had one. It certianly makes me appreciate what good health I do have. Best of luck NE IA Dave
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|