Tractor Talk Discussion Board |
Re: Digging a level trench with a backhoe
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jim in N M on January 09, 2007 at 14:54:08 from (72.16.51.129):
In Reply to: Digging a level trench with a backhoe posted by Terry Edwards on January 09, 2007 at 09:31:05:
Vary interesting subject. I did my filter bed seven yrs. ago, I used something new at that time called "Infilterators" about six ft. long,three ft.wide and about two ft. high, kind of like a quonsit hut look. Each one snapped on to the other one and for a 2800sq. ft. house required eighty ft. total. so I put in two fifty ft. runs. and they MUST be put in level and no gravel required. her in New Mexico every body uses them,not by code but it's quicker and now gravel to mess with. these Infilterators are made I believe in New york state,but almost every sypply house has them. sorry for being windy. Jim in N M
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|