|
Tractor Talk Discussion Board |
Farmall M Hydraulic return Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ponderosa on January 09, 2007 at 01:34:26 from (64.88.211.80):
I have M with belly pump Hyd. It has a rear cylinder which raises a 3 point. The Cylinder has one hose at bottom which is connected to 1 of the 2 1/2" Outlets on the left side of the tractor. I understand both of these connections as well as the one on the right side are all pressure outlets. Problem is, once the line has been pressurized and the cylinder lifted, then the lever control released (Rod pushed all the way down) and no more Hyd pressure applied the cylinder doesnt release (lower) even when we put 400-500lbs of weight on the 3 point.
How do I provide pressure relief for the line/cylinder?
Is there a return connection to the reservoir on the tractor I am missing? Should i connect the top fitting on the cylinder to such a return? Any suggestions?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
