Tractor Talk Discussion Board |
Re: 4320 vs 4020
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by edchainsaw on January 03, 2007 at 19:17:19 from (205.188.117.14):
In Reply to: 4320 vs 4020 posted by Raleigh Boulware on January 03, 2007 at 11:03:50:
we had 4020's with turbo's and a 4620 and used the neighbors 4320 all the time.. I didn't like the lack of torque rise on the 46 and 43's... the 43's I thought were worse in that regard. there is a slight problem in the rearends-- a pin can fall out inside that will cause the gears to lock up...( happend to both of those tractors I drove) the 4020's were peppier to me.. and I loved that 4620 it was awsome for a 10yr old to run that thing ( we had one of the very first 4620's)
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|